Brush Work Order Form -

Define Core Measurement First

Check letters for reference

A CORE LENGTH

This is what the brush is wrapped on without any ends

B CORE O.D:

Outside diameter of the CORE

C THRU BORE-

with Keyway without Keyway

D STUB SHAFT/ KEYWAY

IDLE

SHAFT

KEY WAY

Yes

DRIVE

SHAFT

KEY WAY

Yes

Define Brush Measurements

Check Letter for reference

F BRUSH LENGTH

length of brush AFTER wrapped on the Core

G BRUSH OVER ALL DIAMETER:

Outside diameter of whole brush (including core & materal)

I SET BACK:

Set back = length of core on each side of the material. If the brush length (F) and core length (A) are different, you have a set back. Figure set back; Subtract the brush length from core length, divide by 2 = set back (each end)

E COIL SPACING:

The distance between the wraps in the material on the material on the broom can be: STD, 3'8", 1/2", 7/8' and 1".

H Bristle Type

Material brush is wrapped with: PEX, Poly, Polyester, Nylon and Tampico